In October 1988, the first GSI-made DCCT had been installed in SIS18, Period 09

GS09DT-ML, first beam measured on Nov. 23rd 1988 (3/4 turn into F-Cup S12)

In 1992, a second GSI-DCCT was manufactured, modified according to the requirements of the ESR:

GE02DT-ML, with the associated electronics crate mounted below

As the beam intensities in UNILAC and hence in SIS18 were increased continuously over the years, the GSI-DCCT GS09DT-ML suffered from servo loop stability problems, leading to low frequency oscillations and unreliable results during the acceleration ramp. Hence, in 2006 a commercially available DCCT (Bergoz NPCT) was additionally installed in period S07:

GS07DT-ML, still in lab

The stability problems became visible by recording the normalized output signals of both DCCTs during a typical acc. ramp, at 56mA flat top current:

GS07DT-ML after it was moved to S01 in 2014

After installation, first beam tests showed a much stronger sensitivity against external magnetic fields, dominated by the dipole magnet close by:

vergleich_s09-s07.pdf

After it was moved to period 01, further investigations showed an even stronger influence of magnetic stray fields:

s01dtl_dipoledistortion-5.pdf

The results must be taken into account for any future measures applied to data correction by hard- or software.

DC Beam Current Transformers in SIS18 and ESR - Manuals & Specifications:

GS01DT-ML Bergoz NPCT flyer
GS01DT-ML Bergoz NPCT manual
GS09DT-ML Technical Infos
GE02DT-ML Technical Infos

DC Beam Current Transformers in SIS18 and ESR - Power-Up and Adjustments:

GS09DT-ML: Adjusting of Working and Zero Points
GS09DT-ML: Power-Up & Re-commissioning

GE02DT-ML: Re-commissioning, Adjusting of Working and Zero Points

Since 2015, the old Bergoz-PCT from MSL is installed in the adapted and reconstructed Cryring:

• an electronic front end box is mounted closely to the toroid/beam tube, see below
• a 19“ half-unit electronic backend chassis is installed in the Cryring BI container
• dual-layer inner magnetic shield (μ-metal)
• single-layer outer magnetic shield (soft iron)
• single-turn induction loop wound across yoke of YR08MH for compensation of dI/&dt-induced errors → induced current is coupled into PCT toroid by single-turn winding via adjustable R

YR8DT-L, after additional soft iron shield was added

YR8DT1L, inner μ-metal (dual layer) shield visible

YR8DT1L, Bergoz head amplifier box (viewed from inner side of the ring)

DC Beam Current Transformer in Cryring@ESR - Manual & Specification:

YR8DT1L Bergoz PCT flyer
YR8DT1L Bergoz PCT manual
K. Unser: paper "The PCT..."

S09DT-ML DCCT Documentation

Overview documents:
dcct-s09dtml-overview1.pdf
dcct-s09dtml-overview2.pdf
dcct-s09dtml-overview3.pdf
dcct-s09dtml-overview4.pdf

GS09DT-ML & GE02DT-ML DCCT U/F-Converter Documentation

FG444.021 Schematic and Layout: fg444.021_schaltplan_layout.pdf

Link to SdaOszi021: Analog S09 DCCT Signal