Wiki
Wiki
This is an old revision of the document!
This three T-adapters are optional in use and only fit in in testing case. For use the NI-cable to the PXI7811-board carrying the signals to be examined has to be disconnected at the MAPS-adapter and must be feed to one arm of a T-adapter. Then an additional cable is introduced at the other arm of T-adapter and feed to the origional port at the MAPS-adapter to close the signal line again. Having done that an examination of signals can be executed at VG-pins on the back of the test-crate or with an VG-extender board at the fron side.
Signals to be measured and pins to measure on: |
Use of T-Testadapter:
Gerät | Kabel | Gerät |
---|---|---|
MAPS-Adapter | SHC68-68-RDIO | PXI-7811R FBGA board |
connector (at cable) 68-pin 0.050 D-Type | connector 2/3 (at cable) VHDCI 68-pin male |
|
SH68-68-EP ############## SHC68-68-RDIO | ||
MAPS-Interface (Fa. IMG ) | SHC68-C68-S | PXI-7811R FBGA board |
connector (at cable) VHDCI 68-pin male | connector 0/1 (at cable) VHDCI 68-pin male |
|
SHC68-68-RDIO ############## SHC68-68-RDIO |