Differences

This shows you the differences between two versions of the page.

--- projects:cupid:overview [2019/03/13 16:46]
tobiashoffmann created
+++ projects:cupid:overview [2021/03/16 14:52] (current)
tobiashoffmann
@@ Line 1: / Line 1: @@
-CUPID
+====== CUPID µTCA Settings ======
+**CUPID = Control Unit for Profile and Image Data**
+The microTCA based DAQ for this type of measurements consists of:
+  * Native R2 6 Slot MTCA.4 chassis
+  * CCT AM G64 Xeon CPU
+  * Vadatech AMC217 GbE switch
+  * Nat-Phys-80 MCH
+To optimize the setup following configuration settings were applied:
+on Vadatech AMC217:
+  * connect via local LAN (192.168.40.230) on web browser
+  * disable spanning tree
+  * disable Port 1 on mTCA backplane
+on NAT MCH:
+  * provide web access via console (DHCP on)
+  * via web access disable port 1 and activate Port VLAN
+  * disable in Port VLAN all connections from AMC1-6 to FRT1 and CPU1
+  * enable only link between FRT1 and CPU1 and UPDB and CPU1.
+  * A working config can be loaded {{ :projects:cupid:nat_mch_running_cfg.txt |here}}.
+Example Port VLAN setting:
+{{:projects:cupid:mch_config_cupid_amc217.jpg?400|}}
+====== MCH Hub Module AVR Update ======
+Please check on MCH web access under Board Information, Hub Module Information, the Microcontroller Version number. It should be V1.8 or higher.
+There has been a bug with V1.7 which led to complete PCIe Links loss after setting VLAN parameter, e.g. by loading the nat_mch_running_cfg.txt file.
+To update the AVR for the Hub Module use:
+Update via Web access: {{ :projects:cupid:mch_pcie_webupdate.tar |V1.8}}
+Use the MCH web access, there Update MCH. Upload the tar ball.
+Update via script:
+The hex file for V1.8 is offered at fsl00c tftp server under /lobi/firmware/mch_pcie_x80_avr_pcb1_2_v1_8.hex
+An example script also can be found in the same folder via asl740:/common/tftp/lobi/firmware which needs to be edited before usage.
+The script requires telnet access without pw to the MCH.
+Update manually via CLI on MCH:
+Have the {{ :projects:cupid:mch_pcie_x80_avr_pcb1_2_v1_8.hex |hex}} file.
+Go to MCH command line interface (CLI) and enter diag.
+The select 11, 2, 3.
+Enter 140.181.134.236:/lobi/firmware/mch_pcie_x80_avr_pcb1_2_v1_8.hex
+Reboot MCH. Check new Firmware version under web access/ board information /Hub module information
-CUPID = Control Unit for Profile and Image Data
-The DAQ for this type of measurements

GSI - BEA Wiki

User Tools

Site Tools

Differences

Page Tools