This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
projects:cupid:overview [2019/03/13 16:46] tobiashoffmann created |
projects:cupid:overview [2021/03/16 14:52] tobiashoffmann |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | CUPID | + | ====== |
+ | |||
+ | |||
+ | **CUPID = Control Unit for Profile and Image Data** | ||
+ | |||
+ | The microTCA based DAQ for this type of measurements consists of: | ||
+ | |||
+ | * Native R2 6 Slot MTCA.4 chassis | ||
+ | * CCT AM G64 Xeon CPU | ||
+ | * Vadatech AMC217 GbE switch | ||
+ | * Nat-Phys-80 MCH | ||
+ | |||
+ | To optimize the setup following configuration settings were applied: | ||
+ | |||
+ | on Vadatech AMC217: | ||
+ | * connect via local LAN (192.168.40.230) on web browser | ||
+ | * disable spanning tree | ||
+ | * disable Port 1 on mTCA backplane | ||
+ | |||
+ | on NAT MCH: | ||
+ | * provide web access via console (DHCP on) | ||
+ | * via web access disable port 1 and activate Port VLAN | ||
+ | * disable in Port VLAN all connections from AMC1-6 to FRT1 and CPU1 | ||
+ | * enable only link between FRT1 and CPU1 and UPDB and CPU1. | ||
+ | * A working config can be loaded {{ : | ||
+ | |||
+ | Example Port VLAN setting: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ====== MCH Hub Module AVR Update ====== | ||
+ | |||
+ | Please check on MCH web access under Board Information, | ||
+ | There has been a bug with V1.7 which led to complete PCIe Links loss after setting VLAN parameter, e.g. by loading the nat_mch_running_cfg.txt file. | ||
+ | To update the AVR for the Hub Module use: | ||
+ | |||
+ | Update via Web access: {{ : | ||
+ | Use the MCH web access, there Update MCH. Upload the tar ball. | ||
+ | |||
+ | |||
+ | Update via script: | ||
+ | |||
+ | The hex file for V1.8 is offered at fsl00c tftp server under / | ||
+ | An example script also can be found in the same folder via asl740:/ | ||
+ | The script requires telnet access without pw to the MCH. | ||
+ | |||
+ | Update manually via CLI on MCH: | ||
+ | |||
+ | Have the {{ : | ||
+ | Go to MCH command line interface (CLI) and enter diag. | ||
+ | The select 11, 2, 3. | ||
+ | Enter 140.181.134.236:/ | ||
+ | |||
+ | Reboot MCH. Check new Firmware version under web access/ board information /Hub module information | ||
+ | |||
+ | |||
+ | |||
+ | |||
- | CUPID = Control Unit for Profile and Image Data | ||
- | The DAQ for this type of measurements |