This shows you the differences between two versions of the page.
Next revision | Previous revision Last revision Both sides next revision | ||
projects:cupid:overview [2019/03/13 16:46] tobiashoffmann created |
projects:cupid:overview [2021/02/16 14:36] tobiashoffmann |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | CUPID | + | ====== |
- | CUPID = Control Unit for Profile and Image Data | ||
- | The DAQ for this type of measurements | + | **CUPID = Control Unit for Profile and Image Data** |
+ | |||
+ | The microTCA based DAQ for this type of measurements | ||
+ | |||
+ | * Native R2 6 Slot MTCA.4 chassis | ||
+ | * CCT AM G64 Xeon CPU | ||
+ | * Vadatech AMC217 GbE switch | ||
+ | * Nat-Phys-80 MCH | ||
+ | |||
+ | To optimize the setup following configuration settings were applied: | ||
+ | |||
+ | on Vadatech AMC217: | ||
+ | * connect via local LAN (192.168.40.230) on web browser | ||
+ | * disable spanning tree | ||
+ | * disable Port 1 on mTCA backplane | ||
+ | |||
+ | on NAT MCH: | ||
+ | * provide web access via console (DHCP on) | ||
+ | * via web access disable port 1 and activate Port VLAN | ||
+ | * disable in Port VLAN all connections from AMC1-6 to FRT1 and CPU1 | ||
+ | * enable only link between FRT1 and CPU1 and UPDB and CPU1. | ||
+ | * A working config can be loaded {{ : | ||
+ | |||
+ | Example Port VLAN setting: | ||
+ | |||
+ | {{: |