T-Test7811

These three T-adapters are optional and only fit into the testing crate. For use the NI-cable to the PXI7811-board carrying the signals to be examined has to be disconnected at the MAPS-adapter and must be feed to one arm of a T-adapter. Then an additional cable is introduced at the other arm of T-adapter and feed to the origional port at the MAPS-adapter to close the signal line again. Having done that an examination of signals can be executed at VG-pins on the back of the test-crate or with an VG-extender board at the fron side.

T-Tests internal Signals to be measured and pins to measure on:
Signals to test

Use of T-Testadapter: There are two different sources with two different cables running to the NI PXI-7811R FPGA-board. In order to examine signal flow fit in T-Testadapter by disconnecting direct connection (upper cable) at the MAPS-adapter in built in the “T” and an additional cable (like lower combination):

Device Cable Device
MAPS-Adapter SHC68-68-RDIO PXI-7811R
FBGA board
connector (at cable)
68-pin 0.050 D-Type
T-Adapternutzung connector 2/3 (at cable)
VHDCI 68-pin male
SH68-68-EP ############## SHC68-68-RDIO
MAPS-Interface
(Fa. Hörmann-IMG )
SHC68-C68-S PXI-7811R
FBGA board
connector (at cable)
VHDCI 68-pin male
connector 0/1 (at cable)
VHDCI 68-pin male
SHC68-68-RDIO ############## SHC68-68-RDIO