Cabling for the HTP Experimental Area


Existing Cables & Patch Panels

List of cables (HTP to AP container):

Most of these cables are used by beam loss monitors, the existing RT/FCT transformer combination and camera system for the screen ladder. As these detector installations are virtually permanent, the existing cabling between HTP and AP container is exhausted.

Therefore, all new detector installations will be routed via new cables and patch panels.


New Cables & Patch Panels

The following cables were installed between AP container and HTP beam line:

Cable Requirements, 29th November 2013

Note:
Changes due to Stepper Motor Controller, 1x 25-pin and 1x 9-pin cable, are not included in this scheme.
Infrastructure (no. of 230 V sockets or no. of LAN ports) is yet to be finalised.



Return to HTP main page