This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
projects:ablass:dtim-hardware [2014/11/13 16:00] pmiedzik |
projects:ablass:dtim-hardware [2014/11/13 16:28] (current) pmiedzik [DTim Version 2] |
||
---|---|---|---|
Line 17: | Line 17: | ||
* 1-4x Scaler module | * 1-4x Scaler module | ||
- | * Hardware: | + | * DTim Hardware: |
* Board version: FIXME | * Board version: FIXME | ||
* FPGA firmware: V2.0@2014-10-01 | * FPGA firmware: V2.0@2014-10-01 | ||
Line 31: | Line 31: | ||
==== Lemo Input/ | ==== Lemo Input/ | ||
+ | FIXME Add front panel picture | ||
^ Index ^ Jumper setting ^ Function ^ | ^ Index ^ Jumper setting ^ Function ^ | ||
Line 72: | Line 73: | ||
^ 8 | High impedance | Not used | No | | ^ 8 | High impedance | Not used | No | | ||
- | === Header 3 === | + | ==== Header 3 ==== |
Header 3 is used for debugging purposes. | Header 3 is used for debugging purposes. | ||
Line 94: | Line 95: | ||
* [[projects: | * [[projects: | ||
- | ==== ABLASS Server ==== | + | ==== Diagnostic Tools ==== |
+ | **WARNING!!! Diagnostic tools are available only for Linux Operating system** | ||
+ | |||
+ | === dtim_config === | ||
+ | === dtim_readout === | ||
+ | === dtim_sim === | ||
+ | === dtim_raw === | ||
+ | |||
+ | ===== ABLASS Server | ||
=== Configuration === | === Configuration === | ||
=== Startup === | === Startup === | ||
+ | ablax_ablass process will demonize itself (http:// | ||
+ | There are some important options that can be passed to | ||
+ | * **-d level** debug mask. Default 0 | ||
+ | * **-f** do not demonize, stay in background. | ||
+ | * **-p pid_file** store pid into pid_file file. Default: ./ | ||
+ | * **-c config_file** path co configuration file. Default: ./ | ||
+ | * **-l log_file** path to log file. Default: **./ | ||
+ | |||
+ | === Debug mask === | ||
+ | 0 - no debug/log features\\ | ||
+ | 1 - debug general\\ | ||
+ | 2 - debug cycle'' | ||
+ | 3 - ... \\ | ||
+ | |||
+ |