GSI - BEA Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Data Acquisition for the Ionisation Profile Monitor at SIS18 ======
{{tag>IPM DAQ SIS18 RGM Janztec}}

Two GigE cameras shall be read out on a max. of 200fps rate. Camera triggers need to be created by a timing receiver card. Camera data and operation is handled by a FESA class on a IPC, here the Janztec Sy-IPC-10000. I/O for LEDs etc will be handled by a separate I/O PCI card. Additional data derived from SIS 18 trafo, RF and magnet ramps are converted to frequencies and counted in a latching scaler.

DAQ description: **{{:ds:projects:ipm_sis18:9_2_ipm_daq_software_fesa_20150717.pdf|here}}**

{{:ds:projects:ipm_sis18:ipm_scheme.jpg?nolink|}}

===== Hardware Setup =====
  * Janztec Sy-IPC-10000 IPC, Core i7
  * 1TB harddrive, opt. Raid0 2x240GB SSD, opt.PCIe Raid Controller
  * AddiData I/O (PCI)
  * Dual Port GigE LAN Adapter (PCIe)
  * Latching Scaler
  * CTRI Timing Receiver plus GSI-CERN timing converter

==== Next Steps ====
  * Setup and purchase of hardware
  * Preparation of boot OS and timing
  * I/O Fesa class (TG)
  * Camera Fesa class (??)
  * JAVA GUI

GSI - BEA Wiki

User Tools

Site Tools

Page Tools