This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
optical_setup [2019/03/22 11:45] vschaefer [4. Camera system] |
optical_setup [2019/07/26 10:25] (current) vschaefer |
||
---|---|---|---|
Line 55: | Line 55: | ||
{{: | {{: | ||
- | <color #7092be>Photo of CMOS Camera IDS uEye UI-5240 SE-M-GL.</ | + | <color #7092be>Photos |
- | IDs Ueye | + | **IDs UI-5240SE-M (monochrome)** |
- | | + | |
- | | + | ^ ^specified ^used ^ |
- | * no degradation due to radiation visible so far | + | |interface |GigE | | |
- | * well supported under Linux | + | |sensor | CMOS (e2v) | | |
- | | + | |pixel | 1280 x 1024 |prog. AOI| |
- | Problem | + | |pixel pitch |5.3µm | | |
- | | + | |shutter |global | | |
+ | |max. framerate |50fps |10fps| | ||
+ | |exposure time |9µs - 2s |1ms - 1s | | ||
+ | |binning |h + v (2x) | | | ||
+ | |analog gain boost |2x | | | ||
+ | |ADC |10bit |8bit readout | | ||
+ | |I/O |trigger input |trigger by event | | ||
+ | | |strope output |monitor | | ||
+ | |||
+ | {{:: | ||
- | {{: | ||
For installations, | For installations, | ||
Line 86: | Line 94: | ||
The following drawings show the parts and material to assemble the camera shielding and LED unit on the linear actuator. | The following drawings show the parts and material to assemble the camera shielding and LED unit on the linear actuator. | ||
- | {{:: | + | {{:: |
<color # | <color # | ||
+ | |||
+ | {{:: | ||
+ | |||
+ | <color # | ||
^ ^ Drawing Number^ | ^ ^ Drawing Number^ | ||
| LED Unit | BD-1015625-A-000| | | LED Unit | BD-1015625-A-000| | ||
- | | Camera Unit | BD-1015564-A-000| | + | | Camera Unit | BD-1055194-A-000| |
^ BD-type number ^ Detector ^Linear actuator ^Drawing number ^ | ^ BD-type number ^ Detector ^Linear actuator ^Drawing number ^ |